Samsung STM-19LA/17LA - Manual (Page 8)

15 14
USER’S MANUAL
SPECIFICATIONS
DIMENSION
Model Name STM-19LA STM-17LA
Composite 2ch input 1.0Vp-p, 75Ω terminated, loop-through out
Video S-VIDEO 1ch input (Y/C), loop-through out
VGA 1ch input
Resolution 1280x1024@60Hz
Frequency
Horizontal(KHz) 31KHz ~ 64KHz
Vertical(Hz) 50Hz ~ 75Hz
VGAMode
720x480@60Hz, 720x576@50Hz, 800x600@60/75Hz
1024x768@60/75Hz, 1280x1024@60Hz
Power Consumption Max. 42W Max. 36W
Dimensions Net 430x428x200mm 382.4x390.5x200mm
(WxDxH) Packing 490x506x225mm 436x476x225mm
Weight(kg) Net Weight 6.61Kg 6.20Kg
Gross Weight 8.43Kg 7.73Kg
Power Supply DC 12V / 4.16A
Operating Temperature 50˚F~104˚F (10˚C~40˚C)
Environmental Operating Humidity 10%~80%, Non-condensing
Considerations Storage Temperature -4˚F~113˚F (-20˚C~45˚C)
Storage Humidity 5%~95%,Non-condensing
Size 19" Diagonal AM-TFT 17" Diagonal AM-TFT
Active Display Area 376.32x301.056mm 337.92x270.336mm
Pixel Pitch(mm) 0.294mm(H) x 0.294mm(V) 0.264mm(H) x 0.264mm(V)
LCD Panel Spec Brightness(cd/m2) 300cd/m2
Contrast Ratio 800:1 1000:1
Response Time(ms) 5ms
Viewing Angle(L/R/ T/B) 80/80/75/85 80/80/80/80
STM-19LA STM-17LA
• Technical specifications are subject to change without notice.
TROUBLESHOOTING GUIDE
TROUBLE
No image on display screen
“Going to Sleep” message on
screen
Display image is not centered, too
small or toolarge in PC mode
Vertical or Horizontal noise is
present in the picture
TROUBLESHOOTING TIP
1. Check that power cord of the monitor have been connected securely
into wall outlet or grounded extension cable or strip.
2. Power switch should be in the ON position and LED is lit.
3. Check that the Brightness and / or the Contrast adjustments of the Display haver not
been turned down to minimum levels.
1. The signal cable should be completely connected to the video card / computer
2. The video card should be completely seated in its slot and the computer is
switched ON.
Push the down key in front side or Auto key in remocon.
Adjust Clock and Phase in the OSD.
USER’S MANUAL
POWER MANAGEMENT
MODE POWER CONSUMPTION MODE POWER CONSUMPTION
ON <50W SUSPEND <11W
STANDBY <11W ACTIVE OFF < 8.5W
This monitor features a power management system to “power down” upon receipt of the VESA DPMS(The
display power management signaling) from a VESA DPMS video card. The VESA DPMS-compliant video card
performs this signaling system through not sending horizontal, vertical, or sync signal. This monitor enters an
appropriate mode through identifying each of the three modes of the signaling system.
The power management feature of the monitor is comprised of four stages : On(Green), Standby, Suspend,
Active off(Red on/off 1 sec) and Unsupported mode(Green).
• POWER CONSUMPTION
MODE LED COLOR MONITOR OPERATION
ON GREEN Normal Operation
STANDBY
RED ON/OFF Screen blanks after preset idle time and some electronic circuits or all
SUSPEND
1 SEC circuitry in the monitor shutdown.
ACTIVE OFF
UNSUPPORTED MODE
GREEN Normal operation but the on screen display will show error massage.
POWER OFF RED Not opreation
• LED INDICATOR