Sony STR-DA3200ES - Manual (Page 120)

120 GB
The image of the COMPONENT VIDEO
OUT is corrupted.
• When the signals are output from the
COMPONENT VIDEO OUT jack, input
signals other than 480p are corrupted if
“PROGRESSIVE OUT” is set to “ON.”
Set “PROGRESSIVE OUT” to “OFF.”
• Video input signals other than 480p
component are not received when signals
are output from the S VIDEO jack or the
VIDEO jack. Input 480i component video
signals.
• When component input signals other than
480p are output, use the COMPONENT
VIDEO OUT jack and set
“PROGRESSIVE OUT” to “OFF.”
The source image input from the HDMI
jack is not output from the receiver or
the TV speaker connected to the
receiver.
• Make sure that cables are correctly and
securely connected to components.
• Depending on the playback component,
component may need to be set up. Refer to
the operating instructions supplied with
the each component.
Recording cannot be carried out.
• Check that the components are connected
correctly (page 26).
• Select the source component using INPUT
SELECTOR (page 50).
Tuner
The FM reception is poor.
• Use a 75-ohm coaxial cable (not supplied)
to connect the receiver to an outdoor FM
antenna (aerial) as shown below. If you
connect the receiver to an outdoor antenna
(aerial), ground it against lightning. To
prevent a gas explosion, do not connect the
ground (earth) wire to a gas pipe.
Radio stations cannot be tuned in.
• Check that the antennas (aerials) are
connected securely. Adjust the antennas
(aerials) and connect an external antenna
(aerial), if necessary.
• The signal strength of the stations is too
weak (when tuning in with automatic
tuning). Use direct tuning.
• Make sure you set the tuning interval
correctly (when tuning in AM stations
with direct tuning).
• No stations have been preset or the preset
stations have been cleared (when tuning by
scanning preset stations). Preset the
stations (page 85).
• Press DISPLAY so that the frequency
appears on the display.
RDS does not work.
• Make sure that you are tuned to an FM
RDS station.
• Select a stronger FM station.
The RDS information that you want
does not appear.
• Contact the radio station and find out
whether or not they actually provide the
service in question. If so, the service may
be temporarily out of order.
Receiver
To ground
Ground (earth) wire (not supplied)
Outdoor FM antenna (aerial)