Sunrise Medical V-100 User Manual

Page 15

930482 Rev. A

I X . S e t - U p , A d j u s t m e n t & U s e

D. JOYSTICK SWING-AWAY RETRACTABLE MOUNT

(OPTIONAL)

The joystick is mounted with a mechanism which
allows the control to be locked in a forward or retract-
ed position using magnets.

Adjustment

a. To retract joystick, push outward on the inside of

joystick.

b. Push joystick away from front of armrest until it

locks into retracted position.

c. To return to forward position, push joystick

forward until it locks into place.

E. JOYSTICK

The Quickie V-100 is standard with an integral
controller/joystick.

F. HEIGHT-ADJUSTABLE ARMRESTS (OPTIONAL)

1. Installation

a. Slide the outer armpost into the receiver mount-

ed to the wheelchair frame.

b. The armrest will automatically lock into place.

2. Height Adjustment

a. Rotate release lever to second stop.
b. Slide armrest pad up or down to desired height.
c. Return lever to locked position against armpost.
d. Push arm pad until upper armpost locks firmly

into place.

3. Removing Armrest

a. Rotate release lever to first stop and remove the

armrest.

4. Replacing Armrest

a. Slide armrest back into receiver.
b. Return release lever to locked position

against armpost.

I X . S e t - U p , A d j u s t m e n t & U s e

930482 Rev. A

A. BATTERY REMOVAL

To remove the batteries for transporting
or servicing:

1. Remove Batteries

a. Unplug batteries from controller.
b. Unfasten the battery hold-down straps (A).
c. Remove batteries from rear of chair.
d. Lift up batteries by lifting up on

battery straps (B).

Batteries may weigh up to 40 lbs. Care must be
taken to avoid injury when lifting.

B. SWING-AWAY FOOTRESTS

1. Installation

a. Place swing-away pivot pin into the locating

hole (C) on top of the hanger mount with the
footrest facing outward from frame.

b. Rotate the footrest inward until latch plate locks

(D) into place on locking bolt.

2. Removal

a. To remove footrest, press quick-release lever (E).
b. Rotate footrest outward and lift.

3. Height Adjustment

a. Remove both bolts (F) in the hanger frame tube.
b. Reposition footrest height.
c. Re-tighten all bolts (F).

C. ARTICULATING LEGREST OR ELEVATING LEGREST

(optional)

1. Installation

To install or remove articulating legrest (ALR) or
elevating legrest (ELR) see instructions for
swing-away hangers and footrests.

2. Adjustment

a. To raise legrest, lift to desired position. Legrest

will automatically lock in place.

b. To lower, while seated in chair, press release

lever forward and lower legrest to desired posi-
tion. Legrest will automatically lock in place.

Integral Joystick

Articulating
Legrest

Elevating
Legrest