Scotts Automobile Parts - Manual (Page 9)

4
5
4. Join clevise
Each joint
place with
thread the
move in or
shoulder b
tighten com
5. Next you w
nyloc nuts
After the u
Rev
es to the rod e
will use (3) ½”A
the rod ends i
e rod end in or
r out, the same
bolt in, place tw
mpletely at thi
will need (2) co
. Install the co
upper mount is
v: A Installation M
nds (a‐arms) n
AN washers, (1
in the clevises.
out of the a‐ar
e amount must
wo AN washers
is point. Repea
oilover shocks,
oilover shock in
s tightened, att
anual for Standard
A‐Arm spin
next. You will n
1) shoulder bo
At this point
rm until it does
t be done for t
s on the top of
at this step for
(4) 5/8‐18x3”
nto the upper s
tach the shock
d front steer IFS
ndle assembl
eed (8) ½” sho
lt, and (1) nylo
it will most like
s. (VERY IMPO
he second rod
f the shoulder b
r all 4 a‐arms.
grade 8 yellow
shock mount u
k to the lower a
ly cont
oulder bolts, (2
oc. Beginning w
ely line up, how
ORTANT) Howe
end. Once sa
bolt, and one o
w bolts, (8) 5/8
using (1) 5/8 bo
a‐arm using the
24) ½” AN wash
with the driver
wever if it doe
ever many thre
tisfied with the
on the bottom
grade 8 yellow
olt, (2) 5/8 was
e same hardwa
www.sco
hers, (8) 3/8” n
r’s side lower a
s not, you will
eads one rod en
e alignment pl
under the nylo
w washers, and
shers, and (1) 5
are as the upp
ottshotrods.com
nyloc nuts.
a‐arm, hold it in
need to
nd needs to
ace a ½”
oc. Do not
d (4) 5/8‐18
5/8 nyloc nut.
er mount.
n