Simplicity Manufacturing I7524E - Manual (Page 5)

Intermediate Frame Snowthrowers
6/2006 5 TP 300-5196-00-IS-SN
D
E
G
A
A
Figure 4. Un Folding Handle Bars (Some Models)
A. Upper Handle Assembly E. Locknut, 5/16-18
B. Wing Nuts
F. Cable Ties
C. Lower Handle Assembly G. Lockwasher
D. Special Bolts, 5/16-18 x 2
C
C
C
B
A
D
D
C
Figure 5. Connecting Shift Rods (Some Models)
A. Lower Shift Rod
C. Carriage Bolts
B. Upper Shift Rod D. Locknuts
Assembly
Un-Folding Handles
Folding handles (if equipped) are shipped in the down
position and need to be rotated up and secured. Cut
cable ties (F, Figure 4) that secure control cables to lower
handle assembly (C). Be careful not to cut or damage
the control cables. Loosen wing nuts (B) and remove
any packing materials. Rotate upper handle assembly (A)
up. Slide 5/16-18 special bolts (D) through upper handle
assembly (A) and lower handle assembly (C). Tighten
5/16-18 locknuts (E) and 5/16-18 special bolts (D).
Tighten wingnuts (B), lockwashers (G) and 5/16-18 spe-
cial bolts (D).
F
Assembly
Connecting Shift Rods
On models with folding handles the shift rods need to be
connected. Connect upper shift rod (B, Figure5) and
lower shift rod (A) rods as shown. Secure with carriage
bolts (C) and locknuts (D).
D
B