Woodstock SHOP FOX M1054 - Manual (Page 26)

-16-
M1048 10" x 18" Metal Cutting Bandsaw
O
PE
R
AT
IO
N
S
OPERATIONS
General
The Model M1048 will perform many types of operations
that are beyond the scope of this manual. Many of these
operations can be dangerous or deadly if performed
incorrectly.
The instructions in this section are written with the
understanding that the operator has the necessary knowl-
edge and skills to operate this machine. If at any time
you are experiencing difficulties performing any opera-
tion, stop using the machine!
If you are an inexperienced operator, we strongly recom-
mend that you read books, trade articles, or seek training
from an experienced bandsaw operator before performing
any unfamiliar operations. Above all, your safety should
come first!
READ and understand this entire instruc-
tion manual before using this machine.
Serious personal injury may occur if
safety and operational information is not
understood and followed. DO NOT risk
your safety by not reading!
Always turn the saw OFF and allow the blade to come
to a complete stop before using the vice! Failure to
follow this caution may lead to injury.
Figure 14. Workholding options by
material shape.
Vise
The vise has a quick release feature that allows jaw width
to be quickly adjusted when changing from one sized mate-
rial to another.
To rapidly change the vise jaw gap, do these steps:
1. Turn the handwheel counterclockwise to relieve any
pressure on the vise jaw.
2. Pull or push the jaw in the desired direction.
3. Finish tightening the jaw against the workpiece with
the handwheel.
Note: Figure 14 shows correct methods of holding
different workpiece shapes.