SIIG 04-0322C - Manual (Page 5)

5
For Existing Installation
1.
Install the board and boot up Windows 2000.
2. At the Found New Hardware Wizard, click Next.
3. Select Search for a suitable driver for my device
(recommended) and click Next.
4. Insert the driver CD, check CD-ROM drives, uncheck
the other boxes, and click Next. Click Next again to
continue.
5. Click Finish, remove the driver CD and restart
Windows to complete the driver installation.
Windows XP / Server 2003 (32-bit)
A new installation of Windows XP/Server 2003 requires
a floppy disk for the driver installation. To make this
floppy disk, copy the contents of the 32bit folder, found
on the driver CD, onto a blank floppy disk then follow the
directions below.
For New Installation
1.
Install the board and follow Microsoft procedures
to install Windows accordingly.
2. At the Windows Setup screen, press F6 to install the
driver.
3. Insert the floppy disk that you made above. Press S
then press Enter.
4. Select Silicon Image SiI... for Windows XP/Server
2003, then press Enter.
5. Press Enter to continue and follow on-screen
instructions to complete Windows installation.
For Existing Installation
1.
Install the board and boot up Windows.