SIIG 04-0322C - Manual (Page 13)

13
5. Select Silicon Image... Controller for Windows NT
4.0 and 2000, and press Enter.
6. Press Enter to continue and follow on-screen
instructions to complete Windows NT4.0
installation.
For Existing Installation
1.
Install the board and boot up Windows.
2. Double click My Computer/Control Panel/SCSI
Adapters, then click the Drivers tab.
3. Click Add…, then click Have Disk....
4. Insert the driver CD, type in D:\NT4, then click OK.
(Change D: to match your CD-ROM drive letter)
5. Highlight Silicon Image SiI... Controller and click
OK.
6. Type in D:\NT4, then click OK. (Change D: to
match your CD-ROM drive letter)
7. Click OK, remove the driver CD and restart
Windows to complete the installation.
To Verify Windows NT4.0 Installation
1. Double click My Computer/Control Panel/SCSI
Adapters.
2. Highlight Silicon Image... Controller from SCSI
Adapters listing and click Properties. A message
This device is working properly is displayed in the
dialog box, the driver has been correctly installed.
Note: If an error message is displayed in the dialog
box, install the Serial ATA 4-Channel PCI into a
different PCI slot and reinstall the driver.