beautypg.com

Sony CCD-TRV11 User Manual

Page 55

background image

55

CCD-TRV11/TRV21 3-856-152-52.E/S

Additional information

Información adicional

Symptom

Cause and/or Corrective Actions

• Reset the date and time. (p.43)

• START/STOP MODE switch is set to

or 5 SEC.

m

Set it to

. (p.33)

Picture

Symptom

Cause and/or Corrective Actions

• The viewfinder lens is not adjusted.

m

Adjust the viewfinder lens. (p.13)

• The contrast between the subject and background is

too high. The camcorder is not malfunctioning.
m

Change locations.

• The video heads may be dirty.

m

Clean the heads using the Sony V8-25CLH cleaning cassette.

(p.49)

• The LCD panel is open.

m

Close the LCD panel. (p.17)

• Incorporated fluorescent tube is worn out.

m

Please contact your nearest Sony dealer.

• The camcorder is not malfunctioning.

• The camcorder operates in Demo mode.

m

Exit the Demo mode. (p.69)

Others

Symptom

Cause and/or Corrective Actions

• COMMANDER is set to OFF.

m

Set it to ON. (p.37)

• Something is blocking the infrared rays.

m

Remove the obstacle.

• The battery is not inserted with the correct polarity.

m

Insert the battery with the correct polarity. (p.67)

• The batteries are dead.

m

Insert new ones. (p.67)

• Detach the eyecup and clean the viewfinder lens. (p.50)
• When you use the camcorder where the air pressure is low

such as on a mountain or in an airplane,you may find bubbles
inside the lens. This is not a malfunction. Bubbles will usually
disappear after about a week. But, how long it takes depends
on the air pressure and use.

The date or time indicator
disappears.

Recording stops in a few
seconds.

The image on the viewfinder
screen is not clear.

A vertical band appears when
a subject such as lights or a
candle flame is shot against a
dark background.
The picture is “noisy”.

The picture does not appear
in the viewfinder.

The picture does not appear

on the LCD screen.

A vertical band appears when

shooting a very bright subject.

An unknown picture is displayed.

The supplied Remote
Commander does not work .

There is dust in the viewfinder.

Bubbles appear inside the lens.

(to be continued)