Sanyo VDC-HD3100/HD3100P - Manual (Page 21)

B Detecting motion in specific areas
In [MOTION], after selecting a motion sensor type, click DETAIL to configure the detection conditions on the
detailed configuration screen.
You can configure the camera to “automatically output alarm signals” or “remotely (manually) output alarm
signals”.
You can configure the camera to automatically output an alarm signal when either of its alarm input terminals
receives an alarm signal.
Setting Item Default Setting Optional Setting
ALARM OUT1/ 2 (Alarm
output terminal number)
OFF (Disables alarm output.) ON (Enables automatic alarm output.)
POLARITY (Signal polarity) NO NC
ALARM OUT TIME (Alarm
output time)
5SEC (Ex.: Beeps a warning for 5 sec.) 10SEC to 5MIN
ALARM IN (Output
condition)
ALARM IN1 (Triggers alarm output when
ALARM IN1 terminal receives an alarm
signal.)
ALARM IN2 (Triggers alarm output when
ALARM IN2 terminal receives an alarm
signal.)
MOTION (Output condition)
OFF (Disables alarm output using motion
sensor.)
ON (Triggers alarm output using motion
sensor.)
Use the Remote Alarm buttons ( ) provided on the live screen to send alarm signals from the camera's
alarm output terminals.
Quick Operation Guide 6/10