Scientific Atlanta EPX2203TM - Manual (Page 18)

18 4004041 Rev C
How Do I Connect My Devices to Use the Internet?
3 Connect the active RF coaxial cable to the CABLE connector. Use an optional
cable signal splitter to add a TV, a DHCT or set-top converter, or a VCR.
4 Insert the AC power cord into the POWER connector on the back of the cable
modem, and then plug the cord into an AC power source.
5 Plug in and power on your networked devices including your PC. The cable
modem will then begin an automatic search to locate and sign on to the
broadband data network. This process may take up to 5 minutes. The modem
will be ready for use when the ONLINE LED status indicator on the front panel
stops blinking and illuminates continuously.
6 The next step in setting up your cable modem is to configure your Internet
devices for Internet access. Choose one of the following options:
„ If you want to use Ethernet connections, you must configure the TCP/IP
protocol. To configure the TCP/IP protocol, go to How Do I Configure
TCP/IP Protocol? (on page 19).
„ If you want to use USB connections, you must install the USB drivers. To
install the USB Drivers for USB, go to How Do I Install USB Drivers?
(on page 22).