beautypg.com

Troubleshooting guide – pump – STA-RITE Swimming Pool Filter User Manual

Page 13

background image

13

Read and understand safety and operating instruc-

tions in this manual before doing any work on

pump.
A. Pump does not operate:

1. Check GFCI (Ground Fault Circuit Interrupter) for

proper operation according to GFCI manufac-
turer’s instructions.

2. Check for blown fuses, circuit breakers, or discon-

nected electrical wiring.

3. Check for sand locked impeller. Disconnect power

to motor; follow pump disassembly instructions,
Pages 10 and 11. Clean out sand from impeller
and from wear ring in front plate. Reassemble ac-
cording to instructions, Page 11.

4. Consult dealer/installer or service representative.

B. Motor runs, but does not pump water or pressurize

system:

1. Check to make sure all valves are open.
2. Check skimmer, trap basket, and piping for debris

or obstructions.

3. Check pump impeller for obstructions such as

hair, leaves, grass, or stones. Follow “Pump
Disassembly” instructions, under “Pump Service”
on Pages 10 and 11.

4. Consult with dealer/installer or service representa-

tive.

C. Excessive air in system – pump loses prime:

1. Make sure water level in skimmer is at least 2”

above bottom of skimmer throat with system not
operating.

2. Make sure that there are no leaves in suction pip-

ing and skimmer basket.

3. Make sure there is no vortex (whirlpool) at the

skimmer suction; add water to pool if necessary.

4. Consult dealer/installer or service representative.

D. Circuit breaker in home panel trips repeatedly:

1. Breaker must be of correct rating (see Page 6).
2. If breaker is a GFCI breaker, test according to

GFCI manufacturer’s instructions.

3. Be sure no other lights and appliances are on cir-

cuit.

4. Check wiring size leading to pump. Undersize

wire will cause overheating and excessive amp
draw, leading to the circuit breaker tripping.
Circuit wiring to the receptacle serving the pump
must meet code for the load on the circuit. If in
doubt, consult a licensed electrician.

5. Consult dealer/installer or service representative.

TROUBLESHOOTING GUIDE – PUMP