Speco Technologies P-30FACC - Manual (Page 8)

8
FM/AM TUNER
MEMORY
FUNCTION
4
2 3
5 6 7
1
INSERTING A CASSETTE
The cassette should be inserted edge first with the exposed tape on the right-hand side, push the
cassette into the mechanism until the cassette drops into position.
REMOVING THE CASSETTE
Firmly press the eject button, the cassette will be automatically ejected.
FAST WIND
The cassette can be fast wound in either direction (forward or reverse) to any position on the tape by
pressing and holding one of the fast wind buttons and will be stopped automatically after releasing the
button.
DIRECTION CHANGE
The side of the cassette currently playing can be reversed to play the other side of the cassette at
any time by pressing both fast wind buttons simultaneously.
FM/AM TUNER UNIT
1. Tuner display
2. Memory button
3. Shift button
4. FM/AM selection button
5. Frequency Up / Down button
6. Scan button
7. Set memory button
TUNER OPERATION
For FM reception connect the supplied dipole antenna and 75 adaptor or an outdoor antenna
using 75 coaxial cable to the connector at the rear of the unit. (see page 4)
For AM reception connect the supplied antenna to the AM spring loaded terminals.
1. Select TUNER mode with the Line selector switch.
2. Select FM or AM.
3. Use the UP/DOWN buttons to set a frequency station manually or the SCAN button to
automatically search for the desired station.
4. To program a station press the MEM (Memory) button.
5. Press a MEMORY button (M1 to M5) or SHIFT button and memory button (M6 to M10) to store
a frequency.
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.