Speco Technologies P-30FACC - Manual (Page 5)

5
FRONT PANEL
1) MIC-1 input jack (1/4’’ phone jack). Accepts a balanced low impedance microphone with
a standard 1/4’’ phone plug.
2) Output level indicator. Indicates power output. Do not overload amp.
3) MIC-1 Volume control. Adjusts audio level of MIC-1.
4) MIC-2 Volume control. Adjusts audio level of MIC-2.
5) MIC-3 Volume control. Adjusts audio level of MIC-3.
6) MIC-4 Volume control. Adjusts audio level of MIC-4.
7) Line input selector switch. Allows for selection of high impedance AUX input or music
source from tuner, CD player or cassette player.
8) Line input volume control. Adjusts audio level of line input.
9) Bass control. Low frequency tone control.
10) Treble control. High frequency tone control.
11) Master volume control. Controls all volume levels simultaneously.
12) Power on/off switch with LED indicator. Illuminates when power is on.
13) Zone 4 selector switch. Allows for selection the Zone 4 paging with 70V or 25V line
output. (internally selected, see page 10)
14) Zone 2 selector switch. Allows for selection the Zone 2 paging with 70V or 25V line
output. (internally selected, see page 10)
15) Zone 1 selector switch. Allows for selection the Zone 1 paging with 70V or 25V line
output. (internally selected, see page 10)
16) Zone 3 selector switch. Allows for selection the Zone 3 paging with 70V or 25V line
output. (internally selected, see page 10)
17) All zone selector switch. Allows for selection the All zone paging with 70V or 25V line
output. (internally selected, see page 10)
18) Auto – reverse cassette player unit. (see page 7)
19) FM/AM tuner unit. (see page 8)
20) CD player unit. (see page 7)
REAR PANEL
1) Speaker outputs. Speaker lines must be connected to “COM” and one (and only one) of the
remaining screw terminals.
2) Ground. Cabinet enclosure unit ground.
3) FM antenna input. Connect supplied dipole antenna using supplied 75 matching
transformer or coaxial cable to the antenna connector.
4) AM antenna input. Connect the supplied wire loop antenna to the AM spring loaded
terminals.
5) MOH output terminals. Provided two MOH outputs 600 Ohm, 1 Volt and 8 Ohm, 1 Watt.
6) Manual muting terminals. Provides manual contact closure muting of the AUX and MIC-2~4
inputs during paging.
7) TEL / PAGING balanced input terminals. Accepts a balanced telephone paging signal.