Samsung HT-DS690 - Manual (Page 16)

Connect your pair of
wireless rear speakers,
(L) and (R), to the
wireless rear amplifier. 1 Insert the power plug into an outlet,
and then press the POWER button
on the front panel.
• The Power Standby indicator will light up.
•
To turn off the wireless rear amplifier,
press the POWER button in Standby mode.
2
• Do not connect the wireless rear speakers
to the speaker outputs on the back of the
main unit. Malfunction may result.
• The wireless receiving antenna is built into
the wireless rear amplifier.
Keep the unit away from water and
moisture.
• For optimal listening performance, make
sure that the area around the proposed
wireless rear amplifier location is clear of
any obstructions.
Back of Wireless Rear Amplifier
Wireless Rear Speaker (R) Wireless Rear Speaker (L)
15
Caution
Connecting Wireless Rear Speakers
•
Do not apply a strong shock to the wireless transmission antenna. Breakage may result.
• Do not touch the wireless transmission antenna during operation. Noise or interference to communications may result.
• Place the wireless rear amplifier at the rear of the listening position. If the wireless rear amplifier is too close to the main unit, some sound
interruption may be heard due to interference.
• If you use a device such as a microwave oven, wireless LAN Card, Bluetooth equipment, or any other device that uses the same frequency
(2.4GHz) near the system, some sound interruption may be heard due to interference.
• The transmission distance of radio wave is about 33 feet but may vary depending on your operating environment. If a steel-concrete wall or
metallic wall is between the main unit and the wireless rear amplifier, the system may not operate at all because the radio wave cannot
penetrate metal.
Stand the wireless transmission antenna to face upward for best communication status.
Caution
Note
When using the wireless transmission antenna
1p~42p(DS690)-SEA 9/15/04 5:00 PM Page 18