Samsung SRG-151PT - Manual (Page 7)

1. Remove the two screws at the back of the top cover.
2. Remove the top cover by lifting the back up about 2 inches
and then sliding it forward.
3. Remove the small plug button on the left side of the door
top cap.
4. Remove the three screws on the upper hinge (right side ).
Remove the hinge .
5. Remove the three screws at the left hinge location on the
top plate .
6. Remove the screw in the middle of the top plate and remove
the top plate .
7. Lift the door up and off the bottom hinge (right side ).
8. Tilt the refrigerator cabinet back to remove the right leveling
leg.
9. Romove the secrews on the bottom hinge (right side )and the
left leveling leg. Move the bottom hinge to the left side and
secure it with the screws and leveling leg.
IMPORTANT:The left leg has a spacer that must be moved
to the right side leveling leg when the door swing is reversed.
10. Screw the right leveling leg ,with the spacer in place,back
in place on the right side.
11. Position the door on the left bottom hinge .with the
magnetic gasket holding the door in place replace the top
plateand screws.
12. Make sure the door is aligned with the refrigerator
cabinet before continuing .
13. Secure the top hinge with screws.
14. Slide the top cover back in place and replace the tow screws.
15. Put the plug button in the hole on the right side of the door top cap.
DOOR REVERSAL
Top cover
/ cubierta por cima
Left hinge location
/ colocacion izquierda de gozne
Plug button
/ taco boton
Door top cap
/ tapapor cima
de puerta
Spacer
/ anillo de espaciar
Levelinglegs
/ pie de nivelacion
Upper hinge
/ gozne superior
Top plate
/ lamina por
cima
Bottom hinge
/ gozne inferior
6