Samsung WF-S1061(V/S/C) - Manual (Page 3)

3
Installing the Washing Machine
Unpacking the Washing Machine
Unpack your washing machine and inspect it for shipping damage. Also make sure that you have received all of the
items shown below. If the washing machine was damaged during shipping or you do not have all of the items, contact
your Samsung dealer immediately.
Overview of the washing machine
Selecting a location
Before you install the washing machine, select a location with the following characteristics:
• A hard, level surface (if the surface is uneven, see “Adjusting the leveling feet,” below)
• Away from direct sunlight.
• Adequate ventilation
• Room temperature that will not fall below 0˚C
• Away from sources of heat such as coal or gas Make sure that the washing machine does not stand on its power
cord. Ventilation openings must not be obstructed by carpeting when the washing machine is installed on a
carpeted floor.
Adjusting the leveling feet
If the floor is uneven, adjust the feet (do not insert pieces of wood or any other objects under the feet):
1. Loosen the leg bolt by turning it with your hand until it is at the desired
height.
2. Tighten the locking nut by turning it with the wrench.
• Place the washer on a sturdy, flat surface.
If the washer is placed on an uneven or weak surface, noise or
vibration occurs.
(Only a 1 degrees angle is allowed.)
Control panel
Detergent drawer
Door
Base cover
Adjustable feet
Cover top
Debris filter
Plug
Drain Hose
Cold Water supply
hose
Bolt hole covers
oC rpm Min
Fuzzy control
Temp Spin Delay Start Function
Door open
Power Spin Check
Remaining Time
Delay Start
Rinse Wash Pre-wash
Eco
Speedy Wool
Delicate Synthetic Cotton
START PAUSE
12:00
WF-J1461-02350E-01_EN.indd 3 2007-07-05 ¿АИД 5:39:49