ScyTek Electronics ASTRA 777 Mobile - Manual (Page 22)

· The remote will beep 3 times to indicate the alarm clock has been set. To disable the alarm cloc-
function:
Press and hold Buttons 2 and 3 until the remote beeps three times. · The alarm clock bell and three
bars will be shown indicating alarm clock set mode is entered.
Press Button 1 to disable the alarm clock. · The remote will beep 3 times to indicate the alarm clock
has been disabled.
LCD Backlight
Transmitter Button 5 is used for confirmation, transmitter programming, as well as activation of the
LCD backlighting for use in the dark. Press button 5 to activate the LCD backlight.
System Confirmation
The 2-way transmitter’s confirmation feature allows the current vehicle status to be displayed at any
time.
To display system status:
Press and hold Button 5 until the display shows CON.
· The transmitter will beep once.
Release Button 5.
· The transmitter will beep once.
· The icon representing the system’s current status will be displayed on the LCD panel.
Transmitter Programming
Pressing and holding transmitter button 5 will scroll through several transmitter programmable op-
tions that may or may not be available depending on the model of system installed DEG (degress)
Not applicable on this model.
CHP Sets the siren confirmation chirps ON or OFF:
Press and hold Button 5 until the display shows CHP.
·The transmitter will beep 3 times.
Release Button 5.
· The transmitter will beep once.
· The LCD panel will show a siren if the chirps are enabled or “off” if the chirps are disabled.
PSV Passive function allows the passive arming mode to be enabled or disabled with the transmitter.
Note: This feature may not be available on all systems.
To enable or disable the passive arming mode:
Press and hold Button 5 until the display shows PSV.
· The transmitter will beep five times.
Release Button 5.
· The transmitter will beep once and the system will begin the passive arm mode
· The LCD panel will display “off” and vibrate twice if disabled.
SND Sound function allows disabling of the transmitter’s confirmation tones.To turn the transmitter
confirmation tones on or off:
Press and hold Button 5 until the display shows SND.
· The transmitter will beep four times.
Page 19 - Astra 777 Mobile