Sony STR-DA1200ES - Manual (Page 75)

75 GB
E
n
jo
ying
Surr
o
und S
ound
5
Press V/v repeatedly to select
“Level Settings,” then press
to enter.
6
Press V/v repeatedly to select
“TEST TONE,” then press .
7
Press V.
The test tone is output from each speaker
in sequence.
Also, if you press
v , the pattern will
become the “FIX” pattern in which the
test tone is output from the selected
speaker only.
8
Press to enter.
9
Adjust the speaker level and
balance using the Level
Settings menu so that the level
of the test tone sounds the
same from each speaker.
For details on the Level Settings menu,
see page 56.
Tips
• To adjust the level of all speakers at the same
time, press MASTER VOL +/–.
• The adjusted value is shown on the display
during adjustment.
10
Press V/v repeatedly to select
“TEST TONE,” then press .
11
Press v to select “OFF,” then
press .
The test tone turns off.
12
Press ON SCREEN.
The menu setting display disappears.
When a test tone is not output
from the speakers
• The speaker cords may not be connected
securely. Check to see if they are connected
securely and cannot be disconnected by
pulling on them slightly.
• The speaker cords may have the short-circuit
problem.
When a test tone is output from
a different speaker than the
speaker displayed screen
The location where you set up the speaker (for
example, the front speaker position) and type
of the speaker terminal you connected (for
example, the surround back speaker terminal)
are different. Check the speaker allocation.
For more precise adjustment
You can output the test tone or sound source
from two adjacent speakers to adjust their
balance and level.
Then select the two speakers you want to
adjust by selecting “PHASE NOISE” or
“PHASE AUDIO” in step 6.