Shark EP045 User Manual

Page 5

OPERATING INSTRUCTIONS cont.

PRECAUTIONARY MEASURES

Fig. 6

CAUTION

: The suction hole must

be open, free of any obstructions at

all times. Otherwise, the motor will

overheat and could become damaged.

PLEASE NOTE: The white pleated

filter material in the HEPA Dust Cup

Filter will discolor over time -This is

NORMAL and will NOT affect the

performance of the filter. If the HEPA

Dust Cup Filter

is properly

"TapCleaned”

after each use

and suction

does not return

to 100%, then

we suggest that

the HEPA filter

be “TapCleaned”

vigorously until no

more dust can be removed, then

rinsed under the faucet and allowed to

air dry for 24 hours before refitting into

the vacuum. (Fig. A) Wash once a

month or when suction appears

reduced.

5. Vigorously “TapClean”

the HEPA Dust Cup

Filter on a hard

surface until no more

dust is observed

falling out from

between the pleats of

the filter. (Fig. 6)

Fig. 7

Debris

Screen

6. “TapClean” the Debris

Screen or rinse under

a faucet until clean.

(Fig. 7) Remember

that the Debris Screen

must be completely

air dried for 24 hours

before reinstalling

in the vacuum.

7. Replace the Debris Screen on the

HEPA Dust Cup Filter and reinstall

filter assembly in the vacuum. (not

shown)

Fig. A

Wash once a

month or when

suction

appears

reduced.

Warning:

Allow 24

hours for drying before
replacing in unit.

• Rinse the exhaust filters in lukewarm

water and air dry the filters completely.

Do not use a washing machine to rinse

the filters. Do not use a hair dryer to

dry them. Air dry only for 24 hours.

Never operate the vacuum

without the exhaust filters in

place.

• When the filters are dry,

replace them into the

exhaust filter covers and

replace the filter covers on

the unit.

• A severely soiled or clogged

filter should be thoroughly washed with

fresh tepid water. A mild detergent

can be used if required.

Please Note: The HEPA Dust Cup Filter

is washable. It should, however, be

replaced every six (6) months to ensure

peak performance of your vacuum.

The Exhaust filters are washable. They

should however be replaced every six (6)

months to ensure peak performance of

your vacuum.

Important: Make sure that ALL filters are

completely dry before re-installing back in

the hand vacuum.

Important: All filters should be checked

regularly for signs of damage, preferably

after each cleaning task. The filters must

be replaced immediately if they become

damaged. Always disconnect the vacuum

from the electrical outlet when checking

the filters.

Exhaust

Filter

Cover

Exhaust

Filter Cover

Exhaust

Filter

Exhaus

t Filter

Changing & Cleaning the Exhaust
Filters

The exhaust filters are washable filters

but should be replaced every three (3)

months depending on usage.

• Remove the exhaust filter covers from

the sides of the unit. (See illustration

below.)

Important:

If the suction opening in the unit or the hose becomes blocked, switch off
the vacuum cleaner and remove the blocking substance before you start
the unit again.

Do not operate the vacuum
cleaner to close too heaters,
or radiators.

When pulling out the power plug
from the wall outlet, pull the plug
not the power cord.

Do not pick up anything that is
burning or smoking such as
cigarettes, matches or hot ashes.

Before inserting the power plug
into the wall outlet, make sure that
your hands are dry.

Do not use without HEPA dust cup
filter in place.

Before you start vacuuming,
make sure to remove large or
sharp objects that might
damage the vacuum.

Do not vacuum any liquids.

Keep hair, loose clothing, fingers,
feet and all parts of body away from
openings.