Star Micronics Star DP8340 - Manual (Page 40)

– 36 –
9. DATA STRUCT URE AND CONTROL
9-1. DTR Mode (1 BLOCK)
Controls Data Transfer by using DTR line as BUSY FLAG
(a)
(b) In case of Paper Empty
Paper Empty
When the paper out detector indicates end of paper, the printer stops printing after
a maximum of two lines of printing or paper feed. The printer goes OFF LINE and
sets the DTR to “MARK” status immediately after occurrence of a paper empty.
It is necessary to install paper into the printer and press the ON LINE BUTTON
to light the ON LINE LAMP in order to recover from paper empty status.
Machine Error
A machine error may be generated by paper jamming or when the printer is unable
to print data. When a machine error occurs the printer stops printing. The printer
goes OFF LINE and sets the DTR to “MARK” status immediately after the
occurrence of Machine Error. It is necessary to turn the printer power off and on
again in order to recover from Machine Error.