Smarthome SUPERVISED WIRELESS SECURITY CONSOLE PS561 - Manual (Page 28)

ing the new battery. This ensures that
the sensor is logged into its original
zone number.
MOTION DETECTORS
If any of the Console’s zone indicators
flash slowly, the Motion Detector for
that zone has not reported in during
the last 4 hours. This is most likely
caused by a dead battery in the Motion
Detector.
After replacing the battery in the Mo-
tion Detector, the following steps are
necessary to determine that the Con-
sole still recognizes the Motion Detec-
tor.
1. Place the INSTALL/RUN switch
on the Console to RUN 2.
2. Press [TEST] on the Motion Detector
tor. If the Console chimes, it recog-
nized the Motion Detector and no
further action is necessary.
If you did not hear a chime when
you pressed [TEST):
1. Place the INSTALL/RUN switch
on the Console to INSTALL.
2. Press [TEST] on the Motion Detec-
tor. The Motion Detector transmits
a code to the Console. The Console
acknowledges this with a beep and
logs in the code.
CONSOLE
If you unplug the Console and replace
the battery, you lose all memory of the
installed Door/Window Sensors, Mo-
tion Detectors and Remote Controls.
You then have to set the INSTALL/
RUN switch on the Console to IN-
STALL and reinstall all the Door/
Window Sensors, Motion Detectors
and Remote Controls.
To avoid this, replace the battery with
out unplugging the Console. You do
not lose any stored codes and do not
have to re-install your system.
A 9V alkaline battery will provide at
least 12 hours of back-up. You should
replace the battery at least once a year.
28
Smarthome.com, Inc. (800) SMART-HOME (949) 221-9200 http://smarthome.com