beautypg.com

Arming without the remote control, Sounding the panic alarm, Trouble alarm – Smarthome SUPERVISED WIRELESS SECURITY CONSOLE PS561 User Manual

Page 18: After an alarm

background image

ARMING WITHOUT THE
REMOTE CONTROL

You can arm the system without using

a Remote Control by pressing the

ARM button on the Console. Arming
this way will ALWAYS arm the sys-

tem in the Delay Mode.

SOUNDING THE

PANIC ALARM

HT544 and KF574 Remote Controls

Pressing ARM and DISARM (at the

same time) trips the alarm, even if the
system is not armed, but it doesn’t dial

out unless you arm the system first.

SH624 Remote Control

Pressing (PANIC] trips the alarm,
even if the system is not armed, but it
doesn’t dial out unless you arm the

system first.

TROUBLE ALARM

If you hear a repetitive trouble alarm
when you try to arm the system, there
is a problem and the system does not

arm. You can:

Correct the problem - First press

[DISARM] to stop the trouble

alarm. Then, correct the problem.
Then, arm the system again.

Ignore the problem - While the

trouble alarm is sounding, press

[BYPASS]. The indicator(s) for the

problem zone(s) flash rapidly.

Press [ARM] to arm the system.

The problem zone(s) is/are not be

protected but all other zones arm.

TO SEE THE STATUS

OF ZONES 9-16

If there is a problem with zones 9 -16,

you do not see a flashing zone light
but will hear the trouble alarm if you
try to arm the system. Press and hold

[BYPASS]. This bypasses the problem

and lets you see which zone is report-
ing the problem. If you do not want to

bypass the problem, correct the prob-

lem then arm the system again.

AFTER AN ALARM

When you disarm the system after an

intrusion (or 4 minutes after the alarm
trips) the siren turns off and the lights
which were flashing remain on (to let
you know there has been an intrusion).

The ARMED indicator flashes and the
zone indicator for the violated zone is
on. Press LIGHT ON] or [LIGHT
OFF] on the Remote Control to turn
off the zone indicator and the flashing

ARMED indicator. Press [LIGHT

OFF] to turn off X-10 Modules set to

the same Housecode AND Unit Code

as the Console.

18

Smarthome.com, Inc. (800) SMART-HOME (949) 221-9200 http://smarthome.com