beautypg.com

Sears 28.71234 User Manual

Page 15

background image

13

If you do not set a time, the charger will run for the maximum time. After

selecting the charge rate and proper time, the charger will start charging

after a short delay. To see how much time remains during the charging

process, touch the TIME pad.

RESET:

To stop charging or to change settings once charging has begun,

touch the RESET pad. Then proceed as if you’ve just turned on the

charger.
vOLT/AMP:

When the charger is turned on the METER will display bat-

tery voltage. Touch the VOLTS/AMPS pad to display the charge rate in

amps.
TESTER:

To check the battery’s state-of-charge during charging, touch

the RESET pad and then the TESTER pad. The METER will show the

voltage of the battery. Wait about 5 minutes before taking a reading. To

continue charging, proceed as if you’ve just turned the charger ON.
ENGINE START:

To use the starter feature to help crank the engine of

your vehicle, touch RESET, MANUAL, and ENGINE START - in that

order. Wait for the display to show RDY. The ENGINE START feature

will deliver 275 amps to help crank a 12-volt system or 125 amps to help

crank a 6-volt system. Crank the engine for

no more than 5 seconds.

If it does not start,

wait three minutes before cranking again. During

extremely cold weather, or if the battery is severely exhausted, charge

the battery for about 5 minutes in the 60 AMP setting before cranking the

engine.

CAUTION: DO NOT try to crank an engine without a battery installed. You

may damage the vehicle’s electrical system.

METER:

The meter displays the following information:

—A—

Charge Rate in amps

—V—

Voltage

MAN

Charger is in Manual mode

AUTO

Charger is in Automatic mode

RDY

Charger is ready for cranking