beautypg.com

Automatic tuning, Preset tuning – Sony HT-SL40 User Manual

Page 27

background image

27

GB

HT-SL55 4-247-583-12(1) GB

Receiving Broadcasts

Tips

• If you do not remember the precise frequency, press

TUNING + or TUNING – after entering the value
close to the frequency you want. The receiver
automatically tunes in the station you want. If the
frequency seems to be higher than the entered value,
press TUNING +, and if the frequency seems to be
lower than the entered value, press TUNING –.

• If “STEREO” flashes in the display and the FM

stereo reception is poor, press FM MODE to change
to monaural (MONO). You will not be able to enjoy
the stereo effect, but the sound will be less distorted.
To return to stereo mode, press FM MODE again.

The tuning scale differs depending on the area code as
shown in the following table. For details on area
codes, see page 4.

Area code

FM

AM

CEL, CEK, SP

50 kHz

9 kHz

Automatic tuning

If you don’t know the frequency of the station
you want, you can let the receiver scan all
available stations in your area.

1

Press TUNER repeatedly to select the
FM or AM band.

The last received station is tuned in.

2

Press TUNING + or TUNING –.

Press TUNING + to scan from low to high;
press TUNING – to scan from high to low.
The receiver stops scanning whenever a
station is received.

When the receiver reaches either end of
the band

Scanning is repeated in the same direction.

3

To continue scanning, press TUNING +
or TUNING – again.

Preset tuning

After you have tuned in stations using Direct
Tuning or Automatic Tuning, you can preset
them to the receiver. Then you can tune in any
of the stations directly by entering its
2-character preset code using the supplied
remote. Up to 30 FM or AM stations can be
preset. The receiver will also scan all the
stations that you have preset.

Before tuning to preset stations, be sure to
preset them by performing steps on “Presetting
radio stations”.

Presetting radio stations

1

Press TUNER.

The last received station is tuned in.

2

Tune in the station that you want to
preset using Direct Tuning (page 26) or
Automatic Tuning (page 27).

3

Press MEMORY.

“MEMORY” appears in the display for a
few seconds.
Do steps 4 to 5 before “MEMORY” goes
out.

4

Press PRESET + or PRESET –
repeatedly to select a preset number.

Each time you press the button, the preset
station number changes in the
corresponding order and direction as
follows:

If “MEMORY” goes out before you press
the preset station number, start again from
step 3.

nA1˜A2˜...˜A0˜B1˜B2˜...˜B0N

nC0˜...C2˜C1N

continued

GB07TUN_HT-SL55.p65

28/4/2003, 11:58 AM

27

This manual is related to the following products: