Sony UP-DF500 - Manual (Page 24)

Mis
c
e
llan
eous
Specifications
24
4
Reset the filters and close the cover.
After you have finished all cleaning tasks
Set the main POWER switch on the rear panel to ON,
and then set the ON/STANDBY switch on the front
panel to ON.
The following message appears for about several
minutes.
After the following message is displayed after about
several minutes, you can start printing again.
Specifications
Power requirements
100 to 240 V AC, 50/60 Hz
Input current 4.4 to 1.8 A
Operating temperature
10°C to 30°C (50°F to 86°F)
Operating humidity
20% to 80% (no condensation allowed)
Storage and transport temperature
–20°C to +60°C (–4°F to +140°F)
Storage and transport humidity
20% to 90% (no condensation allowed)
Dimensions About 600 Ч 250 Ч 686 mm (w/h/d)
(23 5/8 Ч 9 7/8 Ч 27 1/8 inches)
Mass Approx. 55 kg (121 lb 4 oz)
Printing system Thermal printing
Resolution
12.59 dot/mm (320dpi)
Gradations 4,096 levels
Maximum print size
401.8 × 335.4 mm
Picture elements
4,224 × 5,060 dots (w/h)
Printing time Approx. 70 sheets/hour (excluding the
time for cooling the head)
Digital interface
Network port × 1
(RJ-45 Modular jack), Conforming
to 100BASE-TX standard
Special output connector × 1
Input connector AC IN (for power)
Accessories supplied
Film tray (1)
Cleaning Kit (1)
Caster for setting the printer vertically
(2)
Stopper sheet (1)
Ferrite cores (2)
AC power cord (1)
a)
Operation Guide (1)
CD-ROM (1)
Floppy disk (1)
Warranty card (1) (for the customers in
the U.S.A and Canada)
a) Footnote for the customers in the U.S.A
and Canada
When you use the printer in the U.S.A. or
Canada, use the AC power cord supplied.
When you use the printer in a country
other than the U.S.A. or Canada, use the
proper AC power cord for your local
power system.
Accessories supplied separately
Blue Thermal Film Printing Pack
UPT-517BL
Cleaning kit UPA-500