Sharp SP-L300 - Manual (Page 25)

| Basic Functions | Input | Picture | Setup | Option |
Turning on the projector
Check that the lens cover is opened completely.
Turn the power on.
Check that the STAND BY LED indicator is turned on.
Press the Power button. While the power is turned on (with the Power button on the remote control or at the
top of the projector), the blue LAMP LED indicator blinks.
When the power is turned on completely, the LAMP LED indicator remains blue.
If the projector is turned on when the lamp is not sufficiently cooled, a temporary loud noise
may be heard because the fan speed increases to cool the lamp.
The STAND BY LED indicator is turned off and the LAMP LED indicator blinks.
The fan speed increases to cool the lamp quickly. When the operation is finished,
the LAMP LED indicator is turned off and the STAND BY LED indicator is turned on and remains blue.
Remove the power cord.
Close the lens cover.
Selecting an input source
Press the SOURCE button (on the remote control or at the top of the projector).
AV, S-Video and HDMI modes can only be selected when an external device is connected, and the PC1
and PC2 modes can be selected regardless of connecting an external device.
| Basic Functions | Input | Picture | Setup | Option |
* Click the Play( )/Stop( ) button in the table below to view the video file.
Turning off the projector
Press the Power button. (Remote control or on top of the projector) OK or Cancel is displayed.
Select OK using the arrow keys (Remote control or on top of the projector).
Press the Enter button or press the Power button again.