Sanus Systems VMF User Manual

Page 2

Concrete, brick and concrete block in-

stallation:

Use the Wall Plate (a) as a template to mark 2

hole locations on the wall. Always locate Con-

crete Anchors (j) in the brick, block, or concrete.

Never drill into the mortar between blocks!

Carefully pre-Drill these holes with a 1/2” ma-

sonry bit to at least 2.5” in depth. Insert a Con-

crete anchor into each of these holes. Make sure

the anchor is seated completely flush with the

concrete surface even if there is a layer of dry-

wall or other material in front. Insert a Lag Bolt

into each Anchor and tighten until they protrude

1/4 inch from the wall.

Attaching the Monitor Plate to the TV:

Mount the assembly to the back of your LCD

television using the M4 Bolts (h) as shown in

Diagram 2. Place the four M4 Bolts through the

holes in TV Mount Plate (b) and tighten into the

VESA bolt mounting pattern on the back of the

television.

Final Assembly:

Next hang the assembly over the Lag Bolts (g)

using the key-holes in the Wall Plate as shown

in Diagram 3. Once the Wall Plate slides down

over the Lag Bolts, firmly tighten them with the

Allen Key (j).

Diagram 1b

concrete or brick surface

Diagram 2

Diagram 3

Wall

Sanus Systems • 2221 Hwy 36 West, St Paul, MN 55113 • 11.15.06 (6901-100048)

Customer Service: 800.359.5520 • See complementary Sanus products at www.sanus.com