Sony IPELA SNC-RH124 - Manual (Page 51)

A
d
mini
s
tra
ting
t
he
Came
ra
Setting the SSL function — SSL Menu
51
OK/Cancel
See “Buttons common to every menu” on page 29.
About the special tags
You can use the following five special tags to allow
notification of the settings acquired by DHCP, such as an
IP address. Type the tags in the parameter section of the
URL that you described in the Message field of the
HTTP.
Use this tag to embed the IP address acquired by DHCP
in the text or parameter.
Use this tag to embed the specified HTTP server port
number in the text or parameters.
Use this tag to embed the MAC address of the interface,
whose IP address was acquired by DHCP, in the text or
parameter.
Use this tag to embed the camera's model name in the
text or parameter.
Use this tag to embed the camera's serial number in the
text or parameter.
Setting the SSL function
— SSL Menu
When you click in the Administrator menu, the
SSL menu appears.
Use this menu to configure the SSL or TLS function.
(called “SSL” hereafter)
The settings allows the camera to communicate with the
client PC by using SSL.
Note
The model on sale in China does not support the SSL
function.
SSL tab
SSL function
On: Select this to use the SSL function. When Allow
HTTP connection for some clients is selected, both
HTTP and SSL connections are allowed. When
Allow HTTP connection for some clients is not
selected, only SSL connection is allowed.
When Microsoft Internet Explorer Ver.6.0 is used
When SSL session is established,
appears in the
status bar on your web browser.
When Microsoft Internet Explorer Ver.7.0 is used
When SSL session is established,
appears in the right
of the address bar on your web browser.
Off: Select this to not use the SSL function. Only HTTP
connection is allowed with the camera.
When you use SSL connection for the first time
When you use SSL connection only with the SSL
function On, you cannot access the camera if the SSL
function does not work properly.
In this case, you must reset the camera to the factory
settings. (All settings will be initialized.)
To avoid this, check that SSL connection is possible by
performing the following steps.
SSL