Simplicity 1180 - Manual (Page 48)

44 TP 400-2307-03-LW-S
Auger and Impeller Group - 24”
NOTE: Unless noted otherwise,
use the standard hardware torque
specification chart.
985466
End of hub to be flush
with end of rolled down
shaft (Ref. 9).
Torque to 30 -34 ft-lbs.
40 - 46 Nm.
Impeller to be positioned
against bearing before
tightening set screw.
Marked side of worm
gear must contact against
left thrust washer to assure
proper gear mesh.
Auger assembly
stamped "R".
Auger assembly
stamped "L".
Torque to
18-21 ft-lbs.
24 - 28 Nm.
Apply grease until
it appears at ends
of auger assembly
(2 places).
Torque to 9 - 11 ft-lbs.
12- 15 Nm.
1
2
3
4
5
6
7
8 9
10
12
13
14
15
16
17
18
19
20
21
22
23
24
25
28
27
2
10
10
6
26
14
18
11
29 29
The above parts group applies to the following Mfg. Nos.:
1693650 860M, 8HP Manual Start
1693651 860M, 8HP Manual Start (Export)
1693763 860M, 8HP Manual Start
1693775 860M, 8HP Manual Start (Export)
1693984 860M, 8HP Manual Start
1693985 860M, 8HP Manual Start (Export)
1694242 860E, 8HP Electric Start
1693652 860DLX, 8HP Manual Start
1693653 860DLX, 8HP Manual Start (Export)
1694241 860DLXE, 8HP Electric Start
© Copyright 2002 Simplicity Manufacturing, Inc. All Rights Reserved.