Simplicity 1180 - Manual (Page 26)

22 TP 400-2307-03-LW-S
Engine & Frame Group - 8HP, Electric Start
NOTE: Unless noted otherwise,
use the standard hardware torque
specification chart.
986111
Hook one end of spring (Ref. 15)
into top hole of roller arm (Ref. 16)
and other end into top hole of the idler
arm assembly in the Traction Drive Group.
Long hub of idler pulley
(Ref. 19) to be toward
idler arm (Ref. 16).
Position idler pulley (Ref. 25)
at center of slot in clutch arm
(Ref. 22).
Hook one end of spring (Ref. 27)
over clutch rod assembly (Ref. 22)
between tabs and other end into
slot in frame.
Use 0-2 washers
between Ref. 40
& 22 to assure a
centered belt and no
interference between
pulleys Ref. 19 & 25.
Position belt stop (Ref. 33)
1/16 to 1/8 inch from belt
when auger clutch is engaged.
Torque to
10-14 ft. lbs. or
14-20 N m
Right rear bolt.
2
1
3
4
5
6
7
8
9
10
11
12 13
14
15
16
17
18
19
20
21
21
22
39
40
25 26
27
28
30
29
31
32
33
34
35
36
37
38
39
39
8
18 18
29
23
24
41
The above parts group applies to the following Mfg. Nos.:
1694242 860E, 8HP Electric Start
© Copyright 2002 Simplicity Manufacturing, Inc. All Rights Reserved.