Sun Microsystems 6900 - Manual (Page 162)

142 Sun StorEdge 3900 and 6900 Series 2.0 Troubleshooting Guide • March 2003
Sun Proprietary/Confidential: Internal Use Only
c. To view details about the Sun StorEdge T3+ Array paths, click the Details
button.
The Multipath Configurator LUN Properties detail window is displayed.
FIGURE 10-6 Multipath Configurator LUN Properties Detail
Note – From this example, note the Primary Path is Unknown and the Alternate
Path is currently in use.
▼ To Use the Sun StorEdge T3+ Array Failover Driver
Command Line Interface (CLI)
Use the jafo_nutil.exe interface, which is available with Sun StorEdge T3+
Array Failover Driver version 2.1 and later, to gather information about:
■ The WWN of monitored Sun StorEdge T3+ array partner groups
■ The WWN of individual LUNs
■ Device paths
■
LUN to drive letter mapping
■ The status for
■
primary paths
■
secondary paths
■
standby paths
■
active paths
In addition, you can use the jafo_nutil.exe interface to perform failback
operations in recovery scenarios.
Although the Sun StorEdge T3+ Array Failover Driver GUI is limited to the Sun
StorEdge 3900 series systems, you can use the CLI for both the Sun StorEdge 3900
series systems and the Sun StorEdge 6900 series systems.