Sun Microsystems 6900 - Manual (Page 149)

Chapter 9 Troubleshooting Virtualization Engine Devices 129
Sun Proprietary/Confidential: Internal Use Only
Diagnosing a creatediskpools (1M)
Failure
When modifying the Sun StorEdge T3+ array configuration on a Sun StorEdge 6900
series, the system should automatically create disk pools. If the virtualization engine
cannot find two paths to all Sun StorEdge T3+ array LUNs, however, the multipath
drives cannot be created. If this happens, the following procedure can help
troubleshoot the problem:
1. Inspect the SUNWsecfg log file ( /var/adm/log/SEcfglog ) to see if any errors are
indicated.
In the following example, creatediskpools (1M) for t3b0 indicates a missing Sun
StorEdge T3+ array path.
Thu May 30 17:35:19 MDT 2002 creatediskpools: t3b0 ENTER: /opt/SUNWsecfg/
bin/creatediskpools -n t3b0.
Thu May 30 17:35:19 MDT 2002 checkslicd: v1 ENTER /opt/SUNWsecfg/bin/
checkslicd -n v1.
Thu May 30 17:35:21 MDT 2002 checkslicd: v1 EXIT.
There are no eligible drives to create MultiPath drive automatically.
Thu May 30 17:35:32 MDT 2002 creatediskpools: ERROR: No mpdrives found on
virtualization engine pair v1.
Thu May 30 17:35:32 MDT 2002 creatediskpools: INFO verify all T3+ array
LUNS have 2 paths to the virtualization engine pair, then re-run
creatediskpools.
Thu May 30 17:35:32 MDT 2002 creatediskpools: Failed to create at least
one disk pool.
Thu May 30 17:35:33 MDT 2002 creatediskpools: t3b0 EXIT.