Sony VPH-D50QM - Manual (Page 21)

21
(EN)
3
Press the MEMORY key to save the adjustment data.
Resetting to the initial preset position
The position of the picture of the video signal can be reset to the initial
preset position by pressing the RESET key in RGB SHIFT adjustment
mode. (The position of the picture of signals other than the video signal
cannot be reset.)
Blanking adjustment
If the displayed picture is larger than the screen, cut off the excess parts.
1
Press the BLKG key.
2
Press the POSITION +/– keys on the remote control to select the part
to be adjusted.
• When you press the + key, the position cycles through the following
order:
TOP
→
BOTTOM
→
LEFT
→
RIGHT
→
TOP
…
• When you press the – key, the position cycles in reverse order.
3
Adjust with the arrow keys.
• Press the
V and v keys to adjust the TOP and BOTTOM positions.
• Press the B and b keys to adjust the LEFT and RIGHT positions.
4
Press the MEMORY key to save the adjustment data.
Note
When you connect multiple video input sources to the projector, such as when
using the switcher, adjust the picture size, picture shift and blanking for each input
connector.
B L K G A D J
T O P
T : 5 0
B : 5 0
L : M A X
R : 5 0
ADJ:
NEXT: + –