Siemens 43B1-M - Manual (Page 15)

Colour monitor 43B1-M
A26361-K883-Z100-1-5E19 English - 13
If you want to change other settings, select the corresponding function from the main menu. All
possible adjustments of the monitor are described in the following.
Setting the contrast of the display ( Contrast )
If the contrast is set too high, bright grey levels can no longer be distinguished from
very bright grey levels. If the contrast is set too low, the maximum brightness will not
be achieved.
Setting the brightness of the display ( Brightness )
Setting the Black level
With the black level you adjust the brightness of the gray-scale values. Resetting the
monitor to the factory settings adjusts the black level to the optimal value.
If the black level is set too high, black surfaces are no longer shown as deep black,
but instead as gray (worse contrast). If the black value is too low, it is not possible to
distinguish between dark shades.
Setting the focus (picture definition) ( Focus )
Eliminate picture noise and improve focus.
Setting the clock (picture width) ( Clock )
Eliminate vertical interference with local fuzziness (synchronisation with the graphic
card signals).
There is only one proper setting per resolution and refresh rate for these parameters.
Adjusting the horizontal position ( H. Position )
Shifting the picture to the left or to the right.
Adjusting the vertical position ( V. Position )
Shifting the picture up or down.
Setting language for the OSD menu ( Language )
You can choose from English (default setting), German, French, Spanish and Italian.
Setting the colour temperature
Setting colour tone of screen to 9300°K (bluish) or 7300°K (less bluish) or to a user-
defined colour temperature.
Resetting the monitor to the factory settings ( Reset )
Executing AUTO LEVEL function
AUTO LEVEL adjusts contrast (video gain) to optimal value and returns contrast
numerical feedback value in the OSD to 50.