SoundCraft UREI 1603 - Manual (Page 21)

21
Cue
Pressing this button routes the pre-fader signal to the headphones and meters. A LED in the switch
indicates when Cue is selected.
Signal-Beat-Peak LED
This LED is green to show when a signal is present, yellow flashes show the beat, and red shows
overload.
Fader
The fader controls the level of the channel’s signal being fed to the A/Master/B selector switch.
CHANNELS 2-7 (2-4 ON 1603) REAR PANEL
CONNECTORS
Mic XLR
Pin 1 Gnd
Pin 2 Hot signal
Pin3
Cold signal
Phono Pair
This stereo pair of sockets has an RIAA filter for turntables. This filter is activated when the Phono/
Line switch, accessible via the hole in the rear panel, is in the ‘phono’ position. This pair of sockets
can be used for line level inputs if the switch is in the ‘line’ position
Line Pair
This stereo pair of sockets is used for line level inputs. There is a boost of +14dB or cut of -10dB
available via switches under the top fascia. These will be set by the installing engineer.
Ground Point
This is for use with turntables which require a ground lead.