SoundCraft UREI 1603 - Manual (Page 13)

13
Undo the 7 (1605) or 6 (1603) Allen screws using a 2mm Allen key. The fader panel can now be lifted clear of the
subframe underneath. Take care not to bend the panel.
Replacing The Channel Faders
Using a 2mm Allen key undo and remove the 2 screws which secure the fader to the fader panel. Unplug the 8-pin connector,
appying slight lateral force to the plug from side to side as you pull the plug from the socket. Plug the connector into the new
fader. The connector is keyed so that it cannot be inserted the wrong way round. Carefully place the new fader back into the fader
panel and secure with the screws removed earlier, DO NOT OVER-TIGHTEN THE SCREWS.
Replacing The Cross- Fader
Using a pozi-screwdriver undo and remove the screws which secure the fader mounting plate to the subframe. Carefully withdraw
the fader, taking care not to damage the wiring harness that is attached to it. Unplug the 6-pin connector, wiggle the plug from side
to side as you pull the plug from the socket. Plug the connector into the new fader. The connector is keyed so that it cannot be
inserted the wrong way round. Carefully place the new fader back into the subframe and secure with the screws removed earlier,
DO NOT OVER-TIGHTEN THE SCREWS. NOTE:Ensure the PCB extrusion is facing the channel faders when replacing the cross
fader.
Replaceable Spares Part Numbers
RS2432 - Urei 1603/5 Crossfader
RS2433 - Urei 1603/5 Channel Fader