beautypg.com

Dj channel 1 rear panel connectors – SoundCraft UREI 1603 User Manual

Page 19

background image

19

Mid

This gives a cut or boost of +/-12dB to frequencies centred at 600Hz

Low

This gives a cut or boost of +/-12dB to frequencies below 60Hz

On

When this switch is depressed its internal LED lights up. This indicates that the channel’s signal is
being routed to the master section. The cue signal (see below) is not affected by the position of the
ON switch.

Cue

Pressing this button routes the pre-fader signal to the headphones and meters. A LED in the switch
indicates when Cue is selected.

Signal-Beat-Peak LED

This LED is green to show signal present, yellow flashes show the beat, and red shows overload.

Fader

The fader controls the level of the channel’s signal being fed to the master buses (left and right).

DJ CHANNEL 1 REAR PANEL CONNECTORS

DJ Mic XLR

Pin 1 Gnd
Pin 2 Hot signal
Pin3

Cold signal

DJ Mic Insert Point 1/4” jack

Tip

Send signal

Ring

Return signal

Sleeve Gnd

Booth defeat Switch

This switch is accessible via the hole in the rear panel.

When it is set to ‘on’ the dj mic will be routed to the booth outputs.

Phono Pair

This stereo pair of sockets has an RIAA filter for turntables. This filter is activated when the Phono/
Line switch, accessible via the hole in the rear panel, is in the ‘phono’ position. This pair of sockets
can be used for line level inputs if the switch is in the ‘line’ position

Line Pair

This stereo pair of sockets is used for line level inputs. There is a boost of +14dB or cut of -10dB
available via switches under the top fascia. These will be set by the installing engineer.

This manual is related to the following products: