Communication setup, When selecting cable, Settings – Sharp AQUOS BD-HP80U User Manual
Page 45
Communication Setup
This allows you to perform and/or change the
communication settings and select the type of Internet
connection from Cable or Wireless (built-in). This
setting is required to use BD-LIVE functions, video
streaming services and software updates that connect
to the Internet.
NOTE
Make sure that the LAN cable is connected to this player
if a wired Internet connection is made. Make sure that the
wireless router/access point is connected to the Internet if
a wireless Internet connection is made. (See pages 20–21.)
For manually performing the setting, the following
information of the connected router or modem is required.
Confirm the information prior to the setting.
IP address, netmask, gateway, DNS address
•
•
−
Sets whether “Cable” or “Wireless”
is used for the network connection
Press HOME to display the menu screen.
Press
a/b to select “Settings”, then press d or
ENTER
.
Press
a/b to select “Communication Setup”,
then press
d or ENTER.
Press
a/b to select “Cable/Wireless Select”,
then press
d or ENTER.
Press
a/b to select “Cable” or “Wireless”, then
press ENTER.
If selecting “Cable”, follow the [When selecting Cable]
directions below, then go to step 4.
If selecting “Wireless”, follow the [When selecting
Wireless] directions on the next page, then go to step
4.
When selecting Cable
Press HOME to display the menu screen.
Press
a/b to select “Settings”, then press d or
ENTER
.
Press
a/b to select “Communication Setup”,
then press
d or ENTER.
Press
a/b to select “Ethernet Setup (Cable)”,
then press
d or ENTER.
1
2
3
4
5
•
•
1
2
3
4
Press
a/b to select “Change”, then press
ENTER
.
Current Ethernet setup info.
: Auto Setup
: Auto Setup
: Auto Setup
: Auto Setup
IP Address
Netmask
Gateway
DNS
Change
Initialize
For initializing the current setting, select “Initialize”,
then press ENTER.
For setting the IP address, press
c/d to select
“Yes” or “No”, then press ENTER.
Do you obtain the IP address
automatically?
IP Address
Netmask
Gateway
Next
Yes
No
If selecting “Yes”: The IP address is automatically
obtained.
If selecting “No”: The IP address, netmask and
gateway are manually entered using the screen for
inputting characters. (See page 46.)
Regarding each of the setup values, confirm the
specifications of your broadband router.
Select “Next”, then press ENTER.
If selecting “Yes” in the step 5, go to the step 9.
Enter your DNS address.
Enter your DNS address.
Primary
Secondary
Next
The primary and secondary DNS addresses are
entered using the screen for inputting characters. (See
page 46.)
Regarding each of the setup values, confirm the
specifications of your broadband router.
Select “Next”, then press ENTER.
5
•
6
•
•
7
•
8
•
9
SETTINGS
(Continued on the next page)
43
Settings