Sony Remote Control Panel RCP-D50/D51 - Manual (Page 54)

54
File Operations
Transferring Scene Files between
the Camera and a Memory Stick
(with the DXC-D50 Series)
When a DXC-D50-series camera is connected, the
registered scene files can be stored as a data block and
can be read when required.
Storing the scene files on a Memory Stick
Proceed as follows:
1
Insert the Memory Stick ( see page 59 ).
2
Press the OTHERS button in the Menu operation
block so that the OTHERS menu is displayed on
the LCD, then press
[RCP Config] to call the RCP
Config menu.
3
Set the menu to Advanced Setting mode.
1) Press [Security] on the RCP Config menu.
2) Press and highlight [Engineer Mode] .
The [Status] , [Menu Set] , and [Code No.]
buttons are displayed.
3) Press [Status] .
The Security Status menu appears.
4) Press [Advance Mode] .
4
Return to the OTHERS menu, and press [File] .
5
Press [File Trans] .
The Scene File Transfer display appears.
6
Press [CAM -> MS] .
A confirmation display appears.
7
Press [Start] .
The registered scene files are transferred to the
Memory Stick.
When the transfer is finished
The termination message “COMPLETED” appears.
Reading the scene files from a Memory
Stick
Proceed as follows:
1
Insert the Memory Stick ( see page 59 ).
2
Operate in the same manner as when you stored
the files until the Scene File Transfer display
appears.
3
Press [MS -> CAM] .
A confirmation display appears.
4
Press [Start] .
The scene files are transferred from the Memory Stick
to the connected camera.
When the transfer is finished
The termination message “COMPLETED” appears.