Superior SLO-SYN SS2000MD4 - Manual (Page 17)

Danaher Motion Superior Electric
SS2000MD4 17 400030-043 Rev G
4.7.4 Timing Requirements
PULSE
Max. Frequency....... 20 kHz
Max. Rise and
Fall Times................ 1 microsecond
Min. Pulse
Width ....................... 25 microseconds
Other Signals
Response Time ....... 25 microseconds
4.5 - 6.0 VDC, 16 mA PER SIGNAL OPTO IN
PULSE
DRIVE
CONTROL SIGNAL
TTL
7406
5V OPTO IN
PULSE
DRIVE
SWITCH
OPTO 5V GND
OPTO IN
PULSE
DRIVE
560 ohms
1/4 watt
12 VDC, 16 mA PER SIGNAL
CONTROL SIGNAL
CONTROL LOGIC COMMON
4.5 - 6.0 VDC, 16 mA PER SIGNAL OPTO IN
PULSE
DRIVE
CONTROL SIGNAL
CONTROL LOGIC COMMON
Figure 4.2 Suggested Methods For Control Interface
4.8 I
NDICATOR
L
IGHTS
"FAULT" LED, Red
Lights to indicate over current condition. This condition is caused by motor wiring errors or a
ground fault.
Recovery from over current condition requires removing and then reapplying the power.