Conversion kit – Smeg PTS605BU3 User Manual
Page 3
Conversion Kit
5
3)
Remove all the burner components in the numerical order shown below:
•
Remove the pan stands (Fig.1) by lifting them from the back (1) and extracting them (2). (On 70 cm
cooktops remove the central pan stand first; on 60 cm cooktops the right-hand pan stand must be
removed first);
•
remove all the knobs (3, Fig. 2) by pulling them outward;
•
lift all the burner components off the cooktop (4-5, Pic. 2);
•
use the wrench 6 (Fig. 3) to open the bayonet fastenings of the burner fixing rings, applying leverage
on the guides 7;
•
after removing all the components described above, lift the front of the cooktop's upper surface (8,
Fig. 4).
•
the burners and gas taps can only be accessed by pushing the rear of the cooktop gently upwards
with the aid of a tool (9-10, Fig. 5).
This is necessary to release the internal snap fixing devices. The cooktop's upper surface can now be
removed. Some models may have 2 additional pins at the side (Fig. 5), which must be removed in the
same way, using a tool to apply leverage to the cooktop.
Fig. 1)
Fig. 2)
Fig. 3)
Fig. 4)
Fig. 5)