Spalding M60 1111 - Manual (Page 9)

08/05 P/N M601111
9
2.
WOOD SCRAP
(NOT SUPPLIED)
2
Bounce middle pole (2) into top pole section (1) using a wood scrap as shown until top
pole no longer moves toward pole identification mark on middle pole.
middle pole
IDENTIFICATION
STICKER
middle pole
IDENTIFICATION
STICKER
5"
1-1/2"
POLE
IDENTIFICATION
MARK
POLE SECTIONS
SHOULD HAVE A
3-1/2" (9 CM)
MINIMUM
OVERLAP.
NOTE:
1
THE IDENTIFICATION STICKER IS
LOCATED 5" FROM THE END OF THE
POLE. WHEN PROPERLY POUNDED
TOGETHER, THE POLE SECTIONS
SHOULD HAVE A 3-1/2" MINIMUM
OVERLAP, LEAVING 1-1/2" BETWEEN
THE OVERLAPPING POLE AND THE
IDENTIFICATION STICKER.
CAUTION!
WARNING
LABEL
2 3
1
I.D. Label I.D. Label
1.
Correctly identify each pole section.