Scag Power Equipment STT-31BSD - Manual (Page 20)

16
Section 4
4.13 ADJUSTING CUTTING HEIGHT
The mower deck can be adjusted from a height of 1-inch
to 6 inches at 1/4-inch intervals. To adjust the cutting
height:
1. Push the cutting height adjustment foot pedal all the
way forward using your right foot until it locks in
place. (Figure 4-6).
2. Insert the lanyard pin into the cutting height index at
the desired cutting height. Push forward on the deck
lift foot lever, hold in place and lift up on the deck
release lever, (Figure 4-7). Slowly release the foot
pedal. A deck height decal is located on the cutting
height index as an aid in adjusting the deck to the
desired height. (Figure 4-6).
Figure 4-7 Deck Release Lever
Figure 4-6 Adjusting Cutting Height
CUTTING HEIGHT
6 5.5
5 4.5
4 3.5
3 2.5
2 1.5
1 481543
390S0140-1
HEIGHT ADJUSTMENT PEDAL
LANYARD
PIN
CUTTING HEIGHT 6 5.5
5 4.5
4 3.5
3 2.5
2 1.5
1
481543
390S0151-1
DECK RELEASE
LEVER