Appendix c - bios recovery – SUPER MICRO Computer SUPERO X8SIA-F User Manual

Page 107

Appendix C: BIOS Recovery

C-1

Appendix C - BIOS Recovery

The recovery procedure described in this section is to be used only when you are
advised by your Supermicro Technical Support representative, or in cases of emer-
gencies where the system no longer can boot due to a corrupted BIOS. DO NOT
re-program (re-flash) the BIOS if your system is running properly.

C-1 Recovery Process from a USB Device/Drive

(Recommended Method)

If the BIOS file is corrupted, and the system is not able to boot up, this feature will
allow you to recover the BIOS image using a USB-attached device. A USB Flash
Drive or a USB CD/DVD ROM/RW drive may be used for this purpose. Please
note that a USB Hard Disk drive is NOT supported at this time. Below is a two-part
procedure to recover the BIOS:

Part 1: Boot Sector Recovery Process

Using a different system, download and copy the correct BIOS binary image

into a USB flash device or a writable CD/DVD disc's Root "\" Directory. Rename the
downloaded file to "super.rom", so the recovery process can recognize and read
the BIOS binary file.
2.

Insert the USB device that contains the new BIOS binary image (“super.rom”)

and power the system down.
3.

While powering on the system, press and hold and simultane-

ously on your keyboard until the USB device's LED indicator comes on. This will
take a few seconds or up to one minute.
4.

Once the USB device's LED is on, release the and keys. The

system may generate beep codes to indicate that the BIOS ROM firmware is being
reprogrammed. The screen will also display a message as shown below. DO NOT
INTERRUPT THIS PROCESS!

This manual is related to the following products:

SUPERO X8SIA