beautypg.com

Installation, Warning – Sanyo MDF-U7486S User Manual

Page 13

background image

- 54 -

12

INSTALLATION

1. Remove the packaging materials and tapes

Remove all transportation packaging materials and tapes. Open the doors and ventilate the unit. If the

outside panels are dirty, clean them with a diluted neutral dishwashing detergent. (Undiluted detergent

can damage the plastic components. For the dilution, refer to the instruction of the detergent.) After

the cleaning with the diluted detergent, always wipe it off with a wet cloth. Then wipe off the panels with

a dry cloth.

2. Adjust the leveling foot

Extend the leveling feet by rotating them

counterclockwise to contact them to the floor.

Ensure the unit is level. (Fig.1)

3. Fix the unit

Two fixtures are attached to the rear of the frame.

Fix the frame to the wall with these fixtures and rope

or chain. (Fig.2)

WARNING

Use a power supply outlet with ground (earth) to prevent electric shock. If the power supply outlet

is not grounded, it is necessary to install a ground by qualified engineers.

Never ground the unit through a gas pipe, water main, telephone line or lightning rod. Such

grounding may cause electric shock in the case of an incomplete circuit.

Fixture

Leveling foot

Fig.1

Fig.2

This manual is related to the following products: