Sony DAV-IS50 User Manual

Page 68

x For the S-AIR receiver

Refer to the operating instructions of the
S-AIR receiver.
When sound transmission is established,
the confirmation display appears.

Note

• Perform the pairing within several minutes after

step 10. If you do not, the pairing is canceled
automatically and the confirmation display
appears. To perform pairing, select [YES]. To
return to the previous display, select [NO].

Press

C/c to select the next operation.

x To finish pairing

Select [NO], then press

x To perform pairing of another S-AIR
sub unit

Select [YES], then press

Note

• If you perform the pairing operation between the

S-AIR main unit and another S-AIR sub unit
(page 66), sound transmission established by ID is
canceled.

• When you perform pairing, [(PAIRING)] appears

beside ID on the display for selecting ID.

To cancel pairing

Perform the ID setting of the S-AIR main unit
according to the procedure of “To set the ID of
the S-AIR main unit” (page 64). If you select a
new ID (you can select the same ID as before),
pairing is canceled.

If sound transmission is
unstable

For the surround amplifier (not supplied)
For the S-AIR receiver (not supplied)

If you use multiple wireless systems which
sharing the 2.4 GHz band, such as wireless LAN
or Bluetooth, the transmission of S-AIR
products or other wireless systems may be
unstable. In this case, the transmission may be
improved by changing the following “RF
CHANGE” setting.

Press SYSTEM MENU.

Press

X/x repeatedly until “RF

CHANGE” appears in the front panel
display, then press

Press

X/x to select the desired setting.

• “AUTO”: Normally select this. The

system change “RF CHANGE” to “ON”
or “OFF” automatically.

• “ON”: The system transmits sound by

searching the better channel for
transmitting.

• “OFF”: The system transmits sound by

fixing the channel for transmitting.

Press .

The setting is made.

Press SYSTEM MENU.

The system menu turns off.

When you set “RF CHANGE” to “OFF,”
select the ID so that sound
transmission is most stabilized
(page 64).

Note

• When the wireless transmitter is not inserted in the

S-AIR main unit, you cannot set “RF CHANGE”.

• In most cases, you will not need to change this

setting.

• If “RF CHANGE” is set to “OFF,” transmission

between the S-AIR main unit and S-AIR sub unit can
be performed using one of the following channels.

– S-AIR ID A: equivalent channel for Wi-Fi

channel 1

– S-AIR ID B: equivalent channel for Wi-Fi

channel 6

– S-AIR ID C: equivalent channel for Wi-Fi

channel 11

• The transmission may be improved by changing the

transmission channel (frequency) of the other
wireless system(s). For details, refer to the operating
instructions of the other wireless system(s).