Sprint Nextel SP7084 - Manual (Page 15)

15 Preparation
ˆ
Preparation
On initial power-up (after all connections are
completed) each station displays
INITIAL
SETUP , prompting you to set the station ID,
time and date.
Important: In this manual, the word “select”
means you must press the button below the
desired option.
SETTING UP THE STATIONS
1. At the INTIAL SETUP screen, select
START .
2. Select NEXT . SET STATION 11
appears.
3. Repeatedly select CHANGE until the
desired extension number (11—22)
appears.
If the number is already used for another
station, an error beep sounds and
nn
NOT AVAIL appears ( nn = the station
number). Select CHANGE to select
another number.
4. Select SAVE . STATION nn SET
appears.
5. Select NEXT . The time setting menu
appears.
6. Use the keypad to enter the hour and
minutes in two digits. Precede a single-
digit hour or minute with 0 (01, 02, 03
and so on).
If you make a mistake, select BACK to
re-enter the correct time.
7. Select SAVE , then NEXT . The AM/PM
selection menu appears.
8. Select CHANGE to toggle between AM
and PM , then select NEXT . The date set-
ting menu appears.
9. Use the keypad to enter the month ( 01 –
12 ) and day ( 01 – 31 ).
If you make a mistake, select BACK to
re-enter the correct date.
10. Select SAVE , then NEXT . The day set-
ting menu appears.
11. Select CHANGE until the correct day of
the week appears. Then select NEXT .
INITIAL SETUP COMPLETE
appears.
12. Write the name or section for each
extension on the supplied extension
card and slide it into the slot on the bot-
tom of the phone.
Note: INPUT CORRECT DATA appears if
you enter an invalid date or time. Check and
correctly enter the data.
VERIFYING THE STATION
AND LINE
CONFIGURATIONS
1. Select LINE 1 . The line indicator lights
green and the speakerphone indicator
lights red. The station ID appears to indi-
cate the station is in use.
2. Using another phone, dial the telephone
number for Line 2. The line indicator for
Line 2 flashes red. If the indicator does
not flash, check for correct installation.
3. Repeat Step 2 for Lines 3 and 4.
If the indicators for all the lines flash, you
have successfully installed this station.
43-5708.fm Page 15 Monday, September 18, 2000 7:56 AM