Woodstock W1410 - Manual (Page 24)

Shop Fox ® Fence -23-
side of the front carriage. Loosen the mounting
screws slightly and shift the carriage so that it is
90˚ to the fence. Figure 33. Tighten the mounting
screws and reinstall the clamping jaws. Check and
adjust the front clamping pressure as described in
Section III, Part D.
Figure 33. Squaring carriage on fence.
Possible problem: The rear carriage may be drag-
ging on the rear rail.
Solution: Although this is unlikely, it is possible
if the rear roller (#51) is pressed onto its bear-
ing (#36) too far. Any one of the following
approaches may be used:
a. Re-install the bearing/roller upside down.
b. Shift the roller on the bearing in a press.
c. Contact Woodstock International for replace-
ment parts (#36, 49, 51 and 52).
d. Use a file to enlarge the rail cut-outs in the rear
carriage slightly.
F. FENCE WILL NOT ADJUST
PARALLEL TO BLADE
Possible problem: The front carriage is not mount-
ed square to the underside of the fence.
Solution: Remove the clamping jaws to gain
access to the mounting screws (#37) on the under