Sundance Spas 850 Series - Manual (Page 5)

• Proper Ventilation: Proper ventilation should be discussed with an Engineer or authority competent enough to understand the necessary pro-
visions needed to vent moist or heated air and air associated with chemical odors outdoors. When the spa is in use considerable amounts of
moisture will escape, potentially causing mold and mildew over time which can damage certain surfaces and/or surroundings.
• Sufficient Access: In the unlikely event that you should ever need to access or gain entry to any portion of the spa for servicing, it is highly
recommended that you plan your indoor installation to provide full access to the entire spa.
• Warranty: Damage caused by not following these guidelines or any improper installation not in accordance to local codes or authorities is not
covered under the spas warranty. Please consult your local state or city building ordinances.
Consider your privacy
In a temperate climate, bare trees in winter
won’t provide much privacy. Think of your spa’s
surroundings during all seasons to determine your
best privacy options. Consider the view of your
neighbors as well, when you plan the location of
your spa.
Provide a view with your spa
Think about the direction you will be facing
when sitting in your spa. Do you have a special
landscaped area in your yard that you find
enjoyable? Can you monitor your children easily
from the spa as they play in the yard? Perhaps there
is an area that catches a soothing breeze during the
day or a lovely sunset in the evening. Consider these
things when you plan your spa location.
Keeping your spa clean
Prevent dirt and foliage from being tracked into
your spa by utilizing concrete for paths and access
areas. Check the location of trees and spill paths
from leaves to see if wind or rain will sweep debris into your spa. And finally, use a high quality cover for when you are not using the spa.
Allow for service access
Many people choose to install tile or custom wood around their spa. If you’re installing your spa with custom decorative trimming, a gazebo
or surrounding structure, or indoors, remember to allow access for service. Should you need service, a technician may need to remove the
spa’s side panels, or access it from beneath. It’s always best to design special installations so that the spa can still be moved, or lifted from the
ground.
Power Limitations (US Models Only)
Sundance Solo, 780 Metro and 680 Denali, Tacoma models include a ten foot GFCI cord for “plug-in” 120V operation. This cord must be
connected directly to a dedicated/grounded wall outlet. NEVER USE AN EXTENSION CORD OF ANY KIND! Using an extension cord can
damage the spa equipment and void the manufacturer warranty! When power runs over 10’ are required, these spas must be hard wired in
accordance with state and local codes.